ET-HP™ is a two-component, high solids, epoxy-based system for
use as a high-strength, non-shrink anchor grouting material. Resin
and hardener are dispensed and mixed simultaneously through the
mixing nozzle. ET-HP meets the ASTM C-881 specifications for Type
I, II, IV and V, Grade 3, Classes B and C, except gel time.
USES:
- Threaded Rod Anchoring
- Bonding hardened concrete to hardened concrete
- Pick-proof sealant around doors,windows and fixtures
- Paste-over for crack injection
The load tables list values based upon results from the most recent
testing and may not reflect those in current code reports. Where code
jurisdictions apply, consult the current reports for applicable load values.
APPLICATION: Surfaces to receive epoxy must be clean. For
installations in or through standing water, see page 225 for details.
The base material temperature must be 40°F or above at the time of
installation. For best results, material should be 70°F - 80°F at the
time of application. Cartridges should not be immersed in water to
facilitate warming. To warm cold material, the cartridges should be
stored in a warm, uniformly heated area or storage container for a
sufficient time to allow epoxy to warm completely. Mixed material in
nozzle can harden in 5–7 minutes at a temperature of 40°F or above.
SHELF LIFE: 24 months from date of manufacture in unopened container
STORAGE CONDITIONS: For best results store between 45°F - 90°F.
To store partially used cartridges, leave hardened nozzle in place. To
re-use, attach new nozzle.
COLOR: Resin – white, hardener – black. When properly mixed, ETHP
adhesive will be a uniform medium gray color.